Upgradekit e3d Hotends HeatBreak+Düse
Produktinformationen "Upgradekit e3d Hotends HeatBreak+Düse"
Heatbreak
This tube is an improvement over the stock E3D HeatBreak. It's made from stainless steel and plated with TwinClad XT coating. TwinClad XT is a very low friction Electroless Nickel composite coating, often used in injection molding because of it release properties. This high lubricity plating will prevent clogging in the critical zone of hotend, where filament liquidizes. It is also very hard and corrosion resistant. Great for high abrasion filaments like Carbon Fiber, Metal filled, Aluminates, etc.
1.75mm Heatbreak
Thread size on heater block side : M6x1
Therad size on heatsink side: M7x1
Stepped inside bore to improve PLA printing.
3mm Heatbreak
Thread size: M6x1
Stepped inside bore to improve PLA printing.
Fits:
- E3D v6 1.75/3mm Direct and Bowden HotEnds.
Nozzle 1.75mm
This is RepRap style nozzle, it is made from a 360 brass base material and plated with TwinClad XT coating. TwinClad XT is a nickel composite coating designed for very low friction. It offers one of the lowest coefficient of friction, better then nickel with PTFE co-deposit. This coating is also very hard and abrasion resistant. If you are working with abrasive Carbon Fiber, Stainless Steel, wood filled or any other metal filled filaments, this will greatly improve the life of your nozzle.
*M6 Thread 1.75mm filament diameter
Orifice size available: 0.20mm, .25mm, .3mm, .4mm, .5mm, .6mm and .8mm
Fits:
- E3D V5-V6 Hotend with 1.75mm Filament
- Original Prusa i3 MK2
- CR10
Nozzle 3mm
This is RepRap style nozzle, it is made from a 360 brass base material and plated with TwinClad XT coating. TwinClad XT is a nickel composite coating designed for very low friction. It offers one of the lowest coefficient of friction, better then nickel with PTFE co-deposit. This coating is also very hard and abrasion resistant. If you are working with abrasive Carbon Fiber, Stainless Steel, wood filled or any other metal filled filaments, this will greatly improve the life of your nozzle.
*M6 Thread 3mm filament diameter.
Orifice size available: .25mm, .3mm, .4mm, .5mm, .6mm and .8mm
Fits:
- E3D 3mm Filament
- Olson Block
- Ultimaker 2+
Anmelden
1 Bewertung
10. April 2018 09:50
Top Alles Super
Alles super gelaufen, schnelle Lieferung