Experimental High-Resolution v6 Nozzle - 1.75mm x 0.15mm

Slicer Settings:

• Nozzle Size: 0.15mm (obviously!)
• Layer Height: We recommend somewhere in the region of 0.08mm. This proved to be the sweet-spot for us.
• Print Speeds: Make sure to turn your speeds and acceleration down. This is all about precision, and precision takes time. We ran our printers at 18mm.s-1, with outline and infill under-speeds at 75-80%. The overhangs were left at the default 45°, and the minimum infill length at 5 mm.
• Retraction: Stringing can be almost entirely tuned away in your retraction settings, however poor tuning can make things much worse due to the higher extrusion forces and pressures. We were using 1mm at 30mm/s-1.

For a full breakdown of the slicer settings please see the documentation on our wiki!