spoolWorks Scaffold Filament - 3mm - 500g

Scaffold is a water-soluble and break-away support filament that actually works.

Scaffold offers total design freedom, helping you to create complex geometries and complete functioning mechanisms in a single print (with no worries about overhangs!). Part of E3D’s spoolWorks range, Scaffold works best with our Edge and PLA filaments.

For a complete overview of Scaffold and what makes it so special, please see our blog.

Features

• Can be broken away or dissolved from prints in normal tap water

• PVA/PVOH-based but easy to print with low viscosity

• Exhaustively tested for exceptional quality

• Lower heat degradation and easily purged from nozzles

• Designed for perfect compatibility with spoolWorks Edge

• Shipped in a re-sealable bag with desiccant for exceptional dryness

Advised print settings:

• PRINT TEMP: 215°C

• BED TEMP: From 20°C to 55C ideally, but will cope with bed temperatures as high as 110°C

• Print Speed: ~50mm/s

Cautionary notes and advice.

• You will need to create specific slicer settings to make the best of Scaffold.

• You will need to create specific slicer settings to make the best of Scaffold.

• Scaffold needs to be kept dry, use the supplied resealable bag, or even better use this specially designed in-bag spool holder.

• Scaffold will degrade if kept for extended periods in a hot nozzle. Do not allow Scaffold to rest in the nozzle at temperature or you risk clogging and damaging the nozzle.

• Please read the documentation in order to use Scaffold at it's full potential

Note: All 3D printers are unique so adjust settings to taste!